Direct Dial Using Access Code

[richard99]

Recently switched form Sipura 3k to OBI110., using latest Software Version 1.3.0 (Build: 2711). Setup completed and have following setup which is working fine as expected.

Sp1 Pbxes
Sp2 Google Voice
and connected with Line port.

But when tried to dial out direct using following access code always disconnected.
* * 1 : Voice Service Provider 1 (SIP or Google Voice)
* * 2 : Voice Service Provider 2 (SIP or Google Voice)
* * 8 : LINE Port (PSTN) Service Provider
* * 9 : OBiTALK Network

Defuault inbound call route for OBiTALK Service is following
{(123456789)>(xx.):SP1},{(123456789):aa},{ph}

I tried all suggestion mentioned in the forum and changed InboundCallRoute but of no use and always disconnection. May be they work with previous version but this latest update may require different way. Any suggestion and require simple call route for Obitalk Service.

In forum some are really so complex that user feel bored and dejected to use.

[richard99]

It seems, it is not a straight to dial out access code unless manually changes are carried out in InboundCallRoute of OBiTALK Service Settings. There are lot information available in forum regarding this issue.

[jimates]

Default settings only allow for calling through the trunk that is designated as primary for outgoing calls. To use other trunks you must set up single stage dialing through any Obi trunk.

RonR put together a single stage dialing configuration for this purpose. Read this post and follow the link at the end of it.
http://www.obitalk.com/forum/index.php?topic=3094.msg20656#msg20656

[richard99]

I have setup Pbxes on SP1 and GV on SP2, callback via PSTN is working great. But there are few burning issue and need help..

1. In callback mode, DTMF tone for input used in Obitalk AA, 50% of time works otherwise AA keep announcing and when hangup after some time Phone attached to port start ringing and will take 2 to 3 minutes to disconnect.
In my InboundCallRoute even I do not have "ph" but still phone rings may be bug.

{(MOBiON)>(xx.):SP1},{(MOBiON)>(<**1:>(Msp1)):sp1},{(MOBiON)>(<**2:>(Msp2)):sp2},{(MOBiON)>(<**8:>(Mli)):li},{(MOBiON):aa}

2. For Disconnect tone I tried all parameters settings from Sipura 3k but did not succeed to make disconnection whence call is over.

3. Obion app needs lot of improvements, does not ring if stay in background, does not work at all if Status is Backing Off.

I am using Sipura 3k and Linksys 3102 for many years, but have to admit in some feature of Obi 110 has no match with Sipura or linksys, particularity callback and setup of Google Voice.