|
Title: Easiest way to temporarily disable 1 port Post by: russws on September 22, 2015, 01:27:51 pm I have a Obi100 with two lines enabled, and I would like the simplest way to temporarily "turn off" one port. Specifically, I don't want calls on that number to ring.
Title: Re: Easiest way to temporarily disable 1 port Post by: azrobert on September 22, 2015, 01:47:51 pm Disable: ***0 x00# (x=1 for SP1 x=2 for SP2) 1 0 1 Enable: ***0 x00# (x=1 for SP1 x=2 for SP2) 2 1 The OBi100 will re-boot. If you want to be able to make outbound calls, you will have to modify the configuration. Voice Services -> SPx Service -> X_InboundCallRoute: {} restamp's suggestion is much better than mine. Title: Re: Easiest way to temporarily disable 1 port Post by: restamp on September 22, 2015, 02:17:51 pm I don't have a 100. I have a 200 and 202, but the following may work on your device as well:
How to create a partial Do-Not-Disturb star code (I chose *88): Star Codes -> Star Code Profile A -> CodeXX Code: *88, Partial DND, set(Sp1($Dnd),1)), set(Sp3($Dnd),1) Save the results. Then, picking up the phone and dialing *88 will put lines 1 and 3 (Service provider 1 and 3) in DND mode. They won't ring while in this mode, and to remind you of this fact, the dial tone presented will be slow-stutter while partial DND is active. Lines 2 and 4 will continue to ring through. Of course, to cancel, just use the DND cancel code: *79. In your case, you'd just set up one SP line in the star code above, allowing the other to continue to ring. Title: Re: Easiest way to temporarily disable 1 port Post by: russws on September 22, 2015, 02:32:25 pm Ahh, that should work just fine. Thanks.
|