|
Title: Configuring more than two lines Post by: hodag on September 14, 2016, 12:57:28 pm I have an Obi202 which is supposed to handle four lines, but I can't figure out how to set this up properly. I have SP 1 routed to virtual phone 1 in Obitalk and SP 2 routed to virtual phone 2 in Obitalk. I have a RJ14 cable physically linking the phone 1 physical port on the back of the Obi to a two-line phone. All of that works fine.
What I would like to do is to connect SP 3 to FAX machine via the phone 2 physical port on the back of the Obi, and I have a long RJ14 cable that reaches to my FAX machine. However, Obitalk only allows ringing on two virtual phones so how do I configure my FAX to work with this setup? Title: Re: Configuring more than two lines Post by: azrobert on September 14, 2016, 02:54:51 pm Route SP3 inbound calls to phone port 2
Setup SP3 to have a double ring Setup your fax to only answer on a double distinctive ring Make the following config changes using OBi Expert: Voice Services -> SP3 Service -> X_DefaultRing: 3 Voice Services -> SP3 Service -> X_InboundCalRoute: ph2 Ring Tone #3 is a double ring |