I would like to take any incoming telephone PSTN calls made to my OBI200 connected to a OBILINE and forward them to my linked device OBI1062.
The reason being is my router is connected to my OBI200 downstairs while my OBI1062 in connected by WIFI upstairs.
I hope I have made myself clear and not confused you all.
Is this at all possible?
Regards
Michael
The easiest way is to route the call to the 1062 over the OBiTalk network.
OBi200:
Physical Interfaces -> Line Port -> InboundCallRoute: ph,pp(123456789)
Replace 123456789 with the OBi1062's 9 digit OBi Number
OBi1062:
Voice Services -> OBitalk Service -> InboundCallRoute: ph
This is the default value, but code might have been automatically added to send calls to the Auto Attendant.
Use OBi Expert to make these config changes.
Quote from: azrobert on March 11, 2017, 05:17:30 PM
Physical Interfaces -> Line Port -> InboundCallRoute: ph,pp(123456789)
That will cause both phones to ring on incoming PSTN calls and either can answer the call. Should you not want that for the OBi200, remove the 'ph,'.
I know this is an old thread. I followed the directions and incoming pstn to obi202 come thru to obi1062.
How can I do the reverse? When I am at the obi1062 and dial the nine digit obi202 number, I need it to go to the usb obiline pstn line.
thanks
Quote from: lageotakes on June 16, 2021, 04:08:35 PM
I know this is an old thread. I followed the directions and incoming pstn to obi202 come thru to obi1062.
How can I do the reverse? When I am at the obi1062 and dial the nine digit obi202 number, I need it to go to the usb obiline pstn line.
thanks
I believe that "When I am at the obi1062 and dial the nine digit obi202 number, I need it to go to the usb obiline pstn line" is not accurately expressing your wish.
Instead, http://www.obitalk.com/forum/index.php?topic=18189.msg108142#msg108142 details what you probably want to happen. Though it refers to OBi2182 and OBi212 the same applies to an OBi1062 and OBi202 with OBiLINE.
Note that as I have never followed those instructions to the letter I have never confirmed that what is posted there contains no errors.
OBi1062
IP Phone -> Phone Settings
Add the following after the beginning parenthesis of the DigitMap:
9xxxxxxx|9xxxxxxxxxx|91xxxxxxxxxx|
IP Phone -> Phone Settings
Add the following to the beginning of the OutboundCallRoute:
{(<9:111111111*>(xxxxxxx|xxxxxxxxxx|1xxxxxxxxxx)):pp},
Replace 111111111 with the OBi Number of the OBi202
OBi202
Voice Services ->OBiTalk Service
Add the following to the beginning of the InboundCallRoute
{222222222>(xxxxxxx|xxxxxxxxxx|1xxxxxxxxxx):li},
Replace 222222222 with the OBi Number of the OBi1062
Dial 9 followed by 7, 10 or 11 digits and the number will be routed to PSTN (OBiLine).
If you don't like the "9" prefix, change it to whatever you want.