|
Title: Can't setup Obi 200; dialed setup number but it just hangs up. Post by: tygunn on December 07, 2017, 09:17:28 am I'm trying to hook up an Obihai 200 device to my Obitalk account.
I'm at this step in setup: http://www.obihai.com/tutorial/ngvtutorial3 When I get to the setup step where you dial **5<num> on the phone, after a short pause, I hear NO voice message and then I'm back to the dialtone. At this point the setup step on the obitalk website never completes, and I am unable to setup the device. I am able to successfully use the **9 222 222 222 loopback service, and I can confirm that my router shows the Obihai 200 on the network. My ethernet switch shows the port the Obi is on is active. However, when I try to http to 192.168.0.92 (the IP for the Obi), I get "connection refused". I have tried factory reset using the hole on the bottom of the device and the *** code numerous times. Disclosure: I found this OBi in the e-waste bin at work, so perhaps there IS a reason it was there. :) Title: Re: Can't setup Obi 200; dialed setup number but it just hangs up. Post by: tygunn on December 07, 2017, 08:49:37 pm I did a firmware update and it helped a bit; I can now access the device's internal server to see configuration,etc. I also now get the "number has been sent to the server" message, but it never adds in the obitalk portal.
Oh well, I'll order a new one; I'm sure there is a good reason this was discarded. Title: Re: Can't setup Obi 200; dialed setup number but it just hangs up. Post by: SteveInWA on December 07, 2017, 09:06:13 pm There a couple of old stalks of celery in my waste basket if you want them...just ask.
|