OBiTALK Community

General Support => On-Topic: Obihai and OBi Products => Topic started by: transam98 on August 09, 2018, 05:28:46 pm



Title: help
Post by: transam98 on August 09, 2018, 05:28:46 pm
So I have a problem.. Obi 508 (basically the same as a 20X)..

Anyways doing the trick (for CALLER ID NAME ETC..) Of Call Centric and Google voice...

PICS BELOW..

When I DIAL Out on the Phone that is connected to JACK 4/SP4 it is dialing out on CALL CENTRIC (NOT GV)... it USED to dial out on GV..

It USED TO WORK FINE and I hadnt changed anything...
Then GV did this big changeover etc. and screwed up a lot.

It hasnt been the same since ! Any help/suggestions would be appreciated..

p.s.. I know  SP8 has NO Checkmark for outgoing.. there is NO PHYSICAL Phone connected to the SP8 JACK... just a FYI :)


Title: Re: help
Post by: drgeoff on August 10, 2018, 01:57:03 pm
When I DIAL Out on the Phone that is connected to JACK 4/SP4 it is dialing out on CALL CENTRIC (NOT GV)... it USED to dial out on GV.
JACK 4 is not "hard wired" to SP4 for either inbound or outbound calls.  Check which SP the Phone Port 4 Primary Line is set to.