What is the reason AA is setup by default on my OBi100 connected to Anveo for E911?
I have this setup for inbound/outbound GV calls via an OBi200 also on my network.
It is basically the default config from OBiTALK.
In use, the OBi100 will be at a remote location on a different network. What will I have to change to allow the 100 and 200 to talk to each other?
I have disabled AA.
Thanks
Quote from: bill-cary on March 04, 2019, 02:54:47 PM
In use, the OBi100 will be at a remote location on a different network. What will I have to change to allow the 100 and 200 to talk to each other?
You will probably need no changes. The Obitalk network (effectively an additional non-configurable preset SP slot on every OBi) is enabled by default. That allows you to call any other OBi by dialling **9 followed by its 9 digit OBi number. (That number is usually on a label on the underside of the OBi.)