OBiTALK Community

General Support => Installation and Set-Up (Devices) => Topic started by: MotoTom on July 11, 2019, 02:03:34 PM

Title: Set Up Auto Firmware Update - OBi200
Post by: MotoTom on July 11, 2019, 02:03:34 PM
I suspect my firmware is outdated since I've never updated it.

I am trying to set up Auto Firmware Update to do weekly checks but when I access the Auto Provisioning page under Expert Configuration, the method is disabled and there's nothing I can do. Attached is what I see on the Auto Provisioning page.

Any help will be greatly appreciated.

Thanks.

Tom
Title: Re: Set Up Auto Firmware Update - OBi200
Post by: ShazamInForum on July 11, 2019, 03:34:20 PM
Use the OBi device local web-portal. 

At phone plugged to the OBi200 device, dial ***1 and note the IP Address.  Open browser (preferably Chrome) on your pc, input the IP Address into the address bar, hit Enter at your keyboard.

Username and Password should be admin/admin (unless you changed it).

To System Management / Auto Provisioning:

Under Auto Firmware Update / Method / uncheck box for Default at right / select drop-down and choose your method.

Also:  Under OBiTALK Provisioning / Method / again, uncheck box for Default at right / select drop-down and choose.

Go to bottom and click Submit to lock changes.  Your OBi device will also reboot.


Good luck!
Title: Re: Set Up Auto Firmware Update - OBi200
Post by: SteveInWA on July 11, 2019, 04:43:19 PM
As far as I know, the auto firmware update settings are no longer used, or no longer work.

The four remaining methods are: