|
Title: Code to change to SP2 Post by: Spikexp on December 22, 2012, 02:16:14 pm Hi,
I want to do something with my Obi. Here is my situation, I have my obi110 with : SP1 as voip.ms (incoming/outgoing) SP2 GV I want to be able to enter a code before the phone number so that the SP2 is use. I want to use it for long or not important phone call. Is there a way to do that? I don't really understand the obi interface, there are so much option. Thank you. Title: Re: Code to change to SP2 Post by: QBZappy on December 22, 2012, 02:54:07 pm Spikexp,
Welcome, Dial **2+number to force the call over SP2. If most calls are going out SP1 consider doing this: Phone PrimaryLine = SP1 Title: Re: Code to change to SP2 Post by: Spikexp on December 22, 2012, 04:34:44 pm Spikexp, Well, now that was easy ;DWelcome, Dial **2+number to force the call over SP2. If most calls are going out SP1 consider doing this: Phone PrimaryLine = SP1 Thank you, it's easier than I thought. Title: Re: Code to change to SP2 Post by: Felix on December 26, 2012, 07:16:22 pm I think QBZappy meant to say in the last line:
Quote If most calls are going out SP2 consider doing this: Phone PrimaryLine = SP2 I assume (and first part of QBZappy's advice assumes) that your current primary line is SP1. That's why you need to force the call over SP2 through **2. If you make SP2 your primary line, you will need to dial **1+number if you want to force calls via SP1. Hopefully, this wasn't too confusing :) Finally, **2 and **1 are defaults, but configurable. I changed my Dad's device to use just * to force non-default line. |