Print Page - Setting up callwithus.com

Title: Setting up callwithus.com
Post by: sorvani on April 26, 2011, 07:14:56 AM

I am having a problem getting callwithus.com set up.

I had no problem doing it in FreePBX, but apparently the different syntax in the OBi110 is confusing me. I don't claim to be an expert by I can follow directions. Can anyone pont me to a good example to follow to set this up?

I use callwithus for calls to Japan because their rates are the same as everyone else for landlines, but usually much lower for mobile.

Title: Re: Setting up callwithus.com
Post by: RonR on April 26, 2011, 08:43:57 AM

A minimal configuration of CallWithUs would be (from factory defaults):

Service Providers -> ITSP Profile A -> General -> STUNEnable : (checked)
Service Providers -> ITSP Profile A -> General -> STUNServer : stun.callwithus.com

Service Providers -> ITSP Profile A -> SIP -> ProxyServer : sip.callwithus.com
Service Providers -> ITSP Profile A -> SIP -> RegistrationPeriod : 120

Voice Services -> SP1 Service -> AuthUserName : username
Voice Services -> SP1 Service -> AuthPassword : password

Physical Interfaces -> PHONE Port -> PrimaryLine : SP1 Service

Title: Re: Setting up callwithus.com
Post by: tkc9789 on April 26, 2011, 04:21:56 PM

Sorvani,
This sounds like the provider I've been looking for. You mind sharing your working configuration after you have this working? Many thanks.

Title: Re: Setting up callwithus.com
Post by: sorvani on April 26, 2011, 10:32:00 PM

The above information is all I entered into my 110 and it registered with CallWithUs just fine. Placed a test call with no issues.

Will report back with any issues after we call the parents a few times.

OBiTALK Community

General Support => Installation and Set-Up (Devices) => Topic started by: sorvani on April 26, 2011, 07:14:56 AM