Annoying Dial tone for Answering machine

<< < (2/2)

LuvU43v3r:
Quote from: robhouston on June 17, 2011, 12:55:41 pm

Setting these parameters at 800ms and 1000ms fixed the problem for me with a Panasonic DEC6 system.

Thanks for the simple suggestion to eliminate this annoying problem.


I have exact Panasonic DEC6 system, but still does not work with Delay = 800ms, Duration = 1000ms. However, my situation is a bit different, I dont have landline connect to LINE port, just GV connects directly to Obi110 and PHONE port connects to the Panasonic base unit.

@ Robhouston: when you got some little time , can you make a setup like mine and confirm if your setting works ? Thanks.

LeftRight:
I don't think LINE port matters.. It should not make any difference with LINE port connected to a landline or not.

I would suggest you try a few other combinations of Delay and Duration.

Keep CPCDuration within range of 800 ms to 1000 ms, you may tune CPCDelayTime down to a much lower value like 100ms or 10 ms, and see how it goes

robhouston:
I didn't have the disconnect problem with GV.  My problem was strictly with the PSTN on the LINE port, and these settings on the PHONE port solved the problem. 

Navigation

[0] Message Index

[*] Previous page