Dial 1 +10 digits to access gv dial 10 digits to use FPL
scansbar:
11 digit dialing from SP1 (GV)
10 digit dialing from SP2 (FPL)
Default Outgoing calls are SP2 (FPL)
Service Providers > ITSP Profile B > General > DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)
I tried the following and it worked, am I missing anything?
(<**1>1xxxxxxxxxx|[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)
ianobi:
Service Providers > ITSP Profile B > General > DigitMap:
(<**1>1xxxxxxxxxx|[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)
Routes eleven digit numbers starting with "1" to sp1(GV). All other numbers route to sp2(FPL) with no change to number formats, e.g. ten digit numbers stay as ten digit numbers rather than having "1" prepended to them. Eleven and ten digit formats should route with no delay. "xx." matches any other number format, but adds up to ten seconds delay before routing the call.
If this works for you then that's fine, stay with it. I was a little confused by your previous comment regarding nine digit numbers.
scansbar:
Thank you, really appreciate your help. You add much value and makes it easier to learn and understand.
Take care
Mark
Lanny:
Hello,
I would like to configure my obi100 like him but I can't edit or erease my digitmap in expert configuration, why?
Thanks!
azrobert:
You must uncheck both boxes to the right of the value.
Navigation
[0] Message Index
[#] Next page
[*] Previous page