Dial Plan Questions..unbelievable answers
azrobert:
Can I talk you out of your plan? I suspect the vast majority of OBi owners don't understand the fine details of how it works and they don't have to. Most people have very simple requirements and the defaults meet most of those and only require small changes. If you post your requirements, I will help you configure your OBi202 and explain why. How's that for an offer?
burrism:
A very gracious offer...
It's evident that besides knowing the product, you have some sort of emotional or operational attachment.
I've never been able to get that attached to things.
I'm 83 years old...come from the world of electronics and telephony and still build my own PCs More important, I read 2 books a week in addition to a full schedule. That's why I hesitate to go swimming in the OBi. However, if you are able to walk me through an easy fix for the digit dialing problem, it would be difficult for me to refuse your kind offer.
I simply want to be able to connect to a 10 digit number..add whatever digits are necessary to work through the auto attendants and when I disconnect, be able to punch my last number redial key and get connected to the original 10 digits..all the while remaining registered on sp1 and sp2 ports and connected to VOIPo.
Good luck to us and thanks again..
drgeoff:
The addition of 'S0' as advised by azrobert will do what you want.
I had used PAP2, SPA3000 and D-Link VTA before encountering my first OBi. Yes, it is different but not really more difficult than the Sipura/Linksys/Cisco units. Do you know that some of the same engineers subsequently designed the OBis?
burrism:
When I go to the expert settings and find the correct digitMap, I see the dial stream and see where the SO needs to be added. Even when I uncheck the OBiTalk settings box and submit, it still will not allow me to add any digits in the field.
If I do get this to change, do I need to do the same on SP2 in order to dial out the same way?
azrobert:
Quote
It's evident that besides knowing the product, you have some sort of emotional or operational attachment.
Attachment? Maybe. I just think these are fantastic little boxes. They can do so much more than a standard ATA and they are in the same price range. They can act almost like a PBX when configured correctly. It's too bad the company is going down the drain concerning the support issue.
Reading thru your posts again, I'm going to make a few assumptions
I think you just defined one trunk, VOIPo on SP1.
You only went thru the trunk setup process once. Correct?
I think you are confusing Phone1 and Phone2 ports for SP1 and SP2.
That is why SP2 is showing unregistered.
If the above is true then the Primary Line for both phone ports is SP1 and you only have to change the ITSP A DigitMap.
In OBi Expert both boxes to the right of the value must be unchecked before you can modify it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page