Question Regarding OBI as a analogue bridge

<< < (2/4) > >>

MBrown:
Just to say that the above set up worked perfectly thanks a lot.

One more question.....

If i wanted to have a hotline from the two analogue phones on the obi202 to the "trunks" on the obi 110's rather than pressing "0" how would i do that?

Thanks again

Marc

azrobert:
Service Providers -> ITSP Profile A General -> DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|<S3:0>|XX.S3)

I changed 0 to <S3:0>
The OBi202 will automatically dial zero if nothing is entered after 3 seconds
You could use S0 and the OBi202 will immediately dial zero, but then you wouldn't be able to dial a number

MBrown:
Thanks I will give that a go tonight

MBrown:
just tried:

Service Providers -> ITSP Profile A General -> DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|<S3:0>|XX.S3)

and when i get dial tone after 3 seconds it dials nothing? even tried S0 and it never dialled zero am i missing something?

Thanks

Marc

azrobert:
Remove <S3:0>| from the ITSP A DigitMap

Physical Interfaces -> Phone1/2 Port -> DigitMap
Add <S3:0>| AFTER the beginning parenthesis

I just learned something today.
The hotkey has to go into the Phone DigitMap.
The last rule in the Phone Port DigitMap (Mpli) points to the Primary (ITSP A) DigitMap, so the ITSP A DigitMap rules are included with the Phone DigitMap rules.
I would think this would work, but it doesn't.

Navigation

[0] Message Index

[#] Next page

[*] Previous page