Can't change password from default

<< < (2/2)

n4mwd:
I was able to change it finally, but the device didn't store it properly.  Now I can't get in with either the new password or the default password.  This time it asked me to supply the new password as soon as I clicked submit.  Before it didn't.  Unfortunately, its not letting me in.  So how do I reset the password back to admin/admin?

I'm not getting notifications so I didn't know you replied to my earlier post until now.

n4mwd:
I found a little button on the bottom of the unit and pressed that.  It restored the default password and also wiped all my configuration that I spent months developing.  Fortunately I had backed up the unit and AA prompts before I pressed the button.

This time I set the new password before I did anything else and it took it this time.  Then I restored the AA prompts and config.  It failed to restore the sip passwords, but fortunately I remembered them.

Is there a way to block obi access to my device?  I don't want them messing with it.  What port or IP address are they using?  I can block that on the router.

drgeoff:
I disabled auto provisioning on a 110 two years ago.  I've never had any problems with Obihai messing with it.

Navigation

[0] Message Index

[*] Previous page