OBI 202 with Obiline will not ring or answer incoming PSTN calls
Mouse:
Thanks very much for a very clever device - worthy successor to the SPA 3102!
I am in the UK. I set up my Obi by allowing network access to the device web interface, applying updated firmware, adding a public DNS provider in WAN internet settings, registering with Obitalk, applying WelshPaul's 17 Nov 2014 UK config, and his UK Obiline config and setup, both from UkVoipForum. I am tailoring my Obi directly, not via Obitalk, so I thought I had better turn off provisioning from Obitalk.
I then set Physical Interfaces ~ Phone 1 to default to using 'PTSN line' as its primary line. And in the Line port settings InboundCallRoute to PH1 (or should it be just PH?).
I can now call outbound over PSTN from a phone attached to Phone 1 socket no problem. But when I arrange for a ring back using the UK line test number 17070 the line (just) fails to ring. By this I mean the phone ringer LED shows a faint light, but no sound comes forth. When I try to pick up the call it will not.
The call history shows incoming on LI1 forked to PH1 and ringing, which seems correct.
(Just to tell you that I have another phone system attached to the PSTN BT socket in parallel. And I use a remote DECT phone jack sometimes. But the problem occurs even if I disconnect both - though I have not disconnected both to try every setting). Also the same complex arrangement used to work with my SPA 3102 OK.
To resolve the problem so far I have tried changing InboundCallRoute from "PH, PH2" to "PH1"; and setting different ring details (taken from my SPA3102) under Phone 1 settings: 20hHz ring frequency, 85 ring volts, Trapezoidal waveform.
I would be very grateful for any thoughts you may have.
Kind regards
Mike
JDDD:
"Phone 1 to default to using 'PTSN line' "
You don't have a PSTN line in a OBI202, if you do not have the usb-extension for PSTN.
InboundCallRoute to PH1:
Just PH1 or PH2.
I can now call outbound over PSTN from a phone attached to Phone 1 socket no problem.
PSTN is outbound. See message above (No PSTN withou USB-extension).
Please: Make more clear what is your config. What are you trying to do.
drgeoff:
Quote from: JDDD on July 07, 2015, 03:39:35 am
"Phone 1 to default to using 'PTSN line' "
You don't have a PSTN line in a OBI202, if you do not have the usb-extension for PSTN.
Yes he does have a PSTN line. The clue is in the topic title.
LTN1:
Quote from: drgeoff on July 07, 2015, 10:30:08 am
Quote from: JDDD on July 07, 2015, 03:39:35 am
"Phone 1 to default to using 'PTSN line' "
You don't have a PSTN line in a OBI202, if you do not have the usb-extension for PSTN.
Yes he does have a PSTN line. The clue is in the topic title.
Why must you always see the obvious! :D
drgeoff:
@mouse
ph and ph1 are synonymous.
I'd guess that you are using a US to UK phone socket adaptor which does not have a ringing capacitor. (Or the adaptor is faulty.)
Navigation
[0] Message Index
[#] Next page