OBI 202 with Obiline will not ring or answer incoming PSTN calls
Mouse:
Quote from: drgeoff on July 09, 2015, 01:22:42 am
I was just suggesting a method of calling the 202 without using the OBiLINE. I hadn't twigged that you also have a 110. If you have both active and with a phone on each one you can call the 202 from the 110 by the 9-digit number on the bottom of the 110.
Standard UK wiring with 4 conductor cable is really only intended for 1 circuit. 3 wires are used. 2 for the speech, line voltage and pulse dialing. The third for the bell. Although many modern phones do not connect to that third wire (they have their own ringing capacitor) the master socket will have a ringing capacitor from that leg to one of the other two.
OK Ta, I guess I need to preface that number by a star code? Sorry I am new to Obi so i don't know these things.
Thaks also for the info on UK connections.
I have just tried the phone with the US style socket connected to PH1, and arranged an inbound PSTN call. The phone rang only once, and I could not pick up the call. Line port was set to direct inbound to "PH1". Physical interfaces ~ Phone 1 primary line was set to PSTN.
But of course that is still testing two things at once. If you give me the code I will do an Obi to Obi call.
drgeoff:
**9 followed by the 9-digit OBi number.
Mouse:
Results:
Using supplied connector to attach phone with US style socket:
Obi110 (Phone w US socket) to Obi202 (Phone on DECT phone jack extender)
Rang and picked up OK but ring tone was US not UK
Obi110 (Phone on DECT extender) to Obi202 (Phone w US socket)
Rang and picked up OK, ring tone was UK
Obi 202 setup as per last post.
(I have installed Welsh Pauls UK settings and then loaded his UK Obiline settings).
Kind regards
Mike
Mouse:
OK did the obvious and reimported the UK settings after checking with Welsh Paul the obiline settings were incorporated in the main file.
I had turned off autoprovsioning, but maybe too late as some settings seemed to be over-written. Others were not which is strange and why I did not notice.
Appears to be working now, but I will keep you updated....
Navigation
[0] Message Index
[*] Previous page