Obi202 setup dead end
robi:
I have nothing connected to the OBi LAN port. The only connection is from the Ethernet (WAN) port directly to the router. I tried changing from Router to Bridge mode. Rebooted to confirm the setting was accepted then rebooted my router and deleted and added the Obi to my desktop. Connection accepted but still shows Offline with firmware update required.
I have the router configured to give the OBI a static IP address (192.168.0.12) could that be causing the problem?
OzarkEdge:
Put the OBi in bridge mode.
Connect it's Ethernet/WAN port to a LAN port on your router.
Set your router to assign a dynamic or static IP address from the pool of IP addresses being used on your LAN... typically 192.168.1.*.
Don't use DMZ or QoS or disable your router firewall.
Do disable any router SIP ALG helper function.
Change the OBi WAN/Internet port from default (2) 10Mbs half-duplex to (1) 100Mbs full-duplex:
Dial *** for Device Configuration Menu
Dial 0 for option
Dial 27# for current value
Dial 1 to set a new value
Dial 1# for new value 100Mbs full-duplex
Dial 1 to confirm/save
Hang up to reboot automatically
OE
robi:
I can't find where to execute this instruction.
"Change the OBi WAN/Internet port from default (2) 10Mbs half-duplex to (1) 100Mbs full-duplex:"
LTN1:
Quote from: OzarkEdge on August 02, 2015, 02:17:56 pm
Change the OBi WAN/Internet port from default (2) 10Mbs half-duplex to (1) 100Mbs full-duplex:
Dial *** for Device Configuration Menu
Dial 0 for option
Dial 27# for current value
Dial 1 to set a new value
Dial 1# for new value 100Mbs full-duplex
Dial 1 to confirm/save
Hang up to reboot automatically
OE
OE...I noticed that you like to give the above recommendation. What practical advantages will the OP or anyone else have from changing the default to 100mbs full duplex on a normal functioning OBi?
OzarkEdge:
Quote from: robi on August 02, 2015, 03:07:46 pm
I can't find where to execute this instruction.
"Change the OBi WAN/Internet port from default (2) 10Mbs half-duplex to (1) 100Mbs full-duplex:"
Dial *** for Device Configuration Menu...
Plug a phone into your OBi phone port and dial ***.
OE
Navigation
[0] Message Index
[#] Next page
[*] Previous page