!Call Bar ??

<< < (2/2)

dstange:
For some reason after I create the map, after I reboot it just goes back to the default digitmap, any ideas?

azrobert:
You can only use one method, local interface or OBiTalk to configure your OBi.
If you use the local interface to configure your OBi you must disable OBiTalk auto provisioning, otherwise OBiTalk will overlay any changes you make.

System Management -> Auto Provisioning
Under OBiTalk Provisioning
Method: Disabled

If you are using OBiTalk to configure your OBi, is there a red ! next to the value?
If there is then uncheck both boxes next to the value to see the real value.
The red ! means the value is not the default.

dstange:
Just logged into the Obi locally, disabled auto provisioning and made changes and they look like they held. Will try again when I get home and post results. I remoted into my laptop @ home then logged into the obi locally from there to make the changes. Thanks again everyone for all your help.

dstange:
Busy signal on the lines I designated for call bar! Thanks again.

Navigation

[0] Message Index

[*] Previous page