Disabling digit map items

(1/4) > >>

Hi-Wire:
Hi there,
 
I use several Obihai devices with Anveo’s hosted service. I need to disable certain digit map items, so that I can access Anveo services. Specifically, I need to disable:
 
##
*12
 
Both of those dials are anveo-specific items that I need to use. Can you please Walk me through how to disable both of those?
 
Thanks.

azrobert:
The following assumes Anveo is defined on SP1 and SP1 is your Primary Line. If Anveo is not defined on the Primary Line, you will need additional code.
Add the following to the ITSP A DigitMap:
*12|##|

If you have an OBi2xx, remove rule "{(<##:>):li}," from the Phone Port OutboundCallRoute.

Hi-Wire:
Thanks!

I could use a bit more clarification, as I still haven't quite gotten this to work.

1. The following assumes Anveo is defined on SP1 and SP1 is your Primary Line.
How do I confirm this?

2. Add the following to the ITSP A DigitMap:
*12|##|
Is the syntax "(" and ")" starts and ends the definition of the ITSP A DigitMap, while "|" separates each parameter? In which case shouldn't I be adding
"|*12|##" right before the final ")"?

3. I use three Obi devices: Obi100, 202 and 508. Does that change your answer?

4. Any other changes I need to make?

Thanks again so much for your help on this!

azrobert:
1. Is Anveo defined on SP1? The Primary Line is found in the Phone Port list of parms. It should be set to "SP1 Service"
2. You are correct if you want to place the code at the end of the DigitMap. My example can be placed anywhere in the DigitMap except at the end.
3. Same for all devices. "##" for the OBi202 is to get dial tone on the Line port, so you must remove the rule I suggested in my last post. The 508 is probably the same.

What is happening when you dial "*12" or "##"?

azrobert:
Do you see anything in the OBi call history?

To access Call History:
Log directly into the OBi using the local interface.
Key the IP address of the OBi into a Web Browser.
Hit Enter
The UserID and default Password are both "admin".
Click Status on the left column.
Then click Call History.

Navigation

[0] Message Index

[#] Next page