How to setup a different ringtone / pattern for each line on OBi1032

<< < (2/2)

giqcass:
Quote from: KrisK on April 03, 2019, 07:52:56 pm

How would you be able to do this?

https://www.obitalk.com/info/documents/admin_guide/OBi1000-IP-Phones-User-Guide.pdf

Load some ringtones on a USB drive and plug it into your OBI IP phone.  It appears to support ".wav" files and ".dat" files.  I don't actually know what other files it supports and the ".dat" files are probably not an audio format. There may be other file types supported but I don't know yet.  I'd suggest testing a few different formats and bitrates.

Start with page 56 of the user guide in the part entitled storage to understand the file transfer process.  There it tells you about how to transfer files from a USB drive to the internal storage of the OBI IP phone.

After that keep reading page 58 tells you how to set ringtones. 


If you plan to use the ringtones you uploaded you can stop here!  Go no further!
In the off chance you want to define ringtones in the advanced menu then use the directions from SteveInWa below. 

Quote from: SteveInWA on August 10, 2015, 01:12:23 pm

Hi:

It isn't obvious, by any means, so don't feel bad.  Refer to the user guide, on page 58:

http://www.obihai.com/docs/OBi1000-IP-Phones-User-Guide.pdf?v=2

Pick one of the "Bell" ring tones, not the default "Office" ringtone, because that ringtone's cadence can't be changed.

You would then need to log into the OBiTALK portal, and get into Expert mode.  Then, go to the Voice Service, and select SP2 or SP3, as appropriate.  Change "X_DefaultRing" to 2 or 3, accordingly, and be sure to save your settings.  The phone should reboot in a minute or so.

I haven't tested this lately, so YMMV.  Please let me know if this makes sense, and if it works.

Navigation

[0] Message Index

[*] Previous page