Can't setup speed dials

[eclas]

Hopefully someone can help me out here. I've searched with no luck.
The problem is I'm trying to setup speed dials via the web interface of the obi 110
Every time I submit the change and then reboot, that particular entry disappears and has the checkmark back on the right side.

Any ideas why they won't hold?

Thanks.

[QBZappy]

eclas,

Hi, Welcome

You can either change this setting on the OBi web page and redo your speed dial.
System Management>Auto Provisioning>Method> = Diabled

OR
leave it the way it is and you can enter the speed dial on the OBi portal.

Your auto-provision setup picks up the settings from the portal or the unit depending how you set it up. You must use one method or the other, but not both when you configure the OBi.

Have a look here for an explanation:   
Managing Your OBi Device Configuration: OBiTALK or OBi Web Page but NOT Both
http://www.obitalk.com/forum/index.php?topic=61.0

[eclas]

Thanks QB, I used the portal and now it's fine.

I should have tried that before I posted.

eclas,

Hi, Welcome

You can either change this setting on the OBi web page and redo your speed dial.
System Management>Auto Provisioning>Method> = Diabled

OR
leave it the way it is and you can enter the speed dial on the OBi portal.

Your auto-provision setup picks up the settings from the portal or the unit depending how you set it up. You must use one method or the other, but not both when you configure the OBi.

Have a look here for an explanation:   
Managing Your OBi Device Configuration: OBiTALK or OBi Web Page but NOT Both
http://www.obitalk.com/forum/index.php?topic=61.0