Analog phone stops working

<< < (2/2)

RonR:
My comments regarding the LINE Port are correct, just not applicable to you.  It's the PHONE Port to LINE Port bypass relay you hear clicking.

I would still bump the PHONE Port voltage up to 52 volts.  The 46 volt default value may be marginal for your particular telephone.  The telephone company normally supplies 48 volts or more (CenturyTel here runs around 56 volts).

timrand:
I just bumped my Phone port voltage to 50 volts and it seemed to solve the problem I was having.  My Panasonic cordless phone would not get dial tone.  I reset the OBI100 that I have and it still did not come back up until I changed the voltage.

This is a new behavior after I updated to the latest firmware day before yesterday.

roborative:
Same here (also Panasonic unit). Thanks!

roborative:
Spoke too soon. Seeing issue again even with 52.

Navigation

[0] Message Index

[*] Previous page