Obi110: My phone will not ring when connected to landline
dgr743:
I recently purchased and set up a Obi110 using a voip provider. That part works great. the problem is, is that when I connect the landline to the line port, and a call comes in on the landline, the phone does not ring. All 3 green lights are on on the front of the 110, and yes the ringer is turned on on the phone. Any help with this is much appreciated. Also the phone is a Panasonic cordless 3 handset. Thanks.
RonR:
Does the rightmost LED blink when a call is coming in the LINE Port?
When a call is coming in on the LINE Port, does it show up in Status -> Call Status and afterward in Status -> Call History?
When a call is coming in on the LINE Port, can you answer the call on the telephone connected to the OBi's PHONE Port even though it's not ringing?
dgr743:
1) Yes the right most light does light up when there is an incoming call.
2)Yes they show up in call history
3) Have not attempted this yet.
I did notice that when the house phones were ringing that the line port light would be flashing for a few rings, then the phone port light would start flashing then the phone connected to the OBI would ring- about a 4 to 5 second delay.
Quote from: RonR on June 14, 2011, 12:27:51 pm
Does the rightmost LED blink when a call is coming in the LINE Port?
When a call is coming in on the LINE Port, does it show up in Status -> Call Status and afterward in Status -> Call History?
When a call is coming in on the LINE Port, can you answer the call on the telephone connected to the OBi's PHONE Port even though it's not ringing?
RonR:
Quote from: dgr743 on June 15, 2011, 12:35:03 am
I did notice that when the house phones were ringing that the line port light would be flashing for a few rings, then the phone port light would start flashing then the phone connected to the OBI would ring- about a 4 to 5 second delay.
That's exactly what's supposed to happen. The OBi has to wait for the second ring on the LINE Port in order to obtain CallerID. CallerID is needed in case the incoming call is to be routed somewhere other than the OBi PHONE Port. Once it's determined the call is destined for the PHONE Port, the OBi rings the PHONE Port.
dgr743:
Ok is there a setting I can change to where they ring immediately?
Navigation
[0] Message Index
[#] Next page