Cannot configure Obi100 to use Google Voice

(1/3) > >>

kliu888:
I have my Obi100 configured with SP1 for Google Voice & SP2 for Call with Us (SIP). This works fine until yesterday it did an automatic firmware upgrade to 1.3.0 build 2872. Now it no longer connects to ObiTalk web portal and all configurations were lost.

I manually configured it but only SIP works, not Google Voice. The status shows "Service Not Configured." I have another Obi100 with older firmware (2774) which works perfectly with Google Voice & SIP. I made sure all the settings on both devices are the same but the one with newer firmware always shows "Service Not Configured." And yes, I only have one device connect to WAN at a time so it's not because both of them trying to log into the same GV account.

Is there something else I have to do in order to get Google Voice to work with the new firmware? The following is what I've done for GV which works for older firmware:

1. ITSP Profile A -> General -> Name: Google Voice
2. ITSP Profile A -> General -> SignalingProtocal: Google Voice
3. Voice Services -> SIP Credentials -> AuthUserName: (GV username)
4. Voice Services -> SIP Credentials -> AuthPassword: (GV password)

Everything else is left as default.

Any help would be greatly appreciated.

Thank you very much.

SteveInWA:
You set up your Google Voice service a long time ago.  The old method no longer works.

Read my detailed instructions here, to configure GV:

http://www.obitalk.com/forum/index.php?topic=8560.msg56460#msg56460

kliu888:
Thank you, Steve. So it won't work without ObiTalk portal even though it has the latest firmware? Looks like Obihai changed the firmware so that you must use ObiTalk portal because my other device with older firmware works with GV (I just set it up successfully with manual configuration today). That's too bad because I could not add my device to the web portal. Every time I dial the **5 xxxx the device just reboots. >:(

SteveInWA:
There has already been extensive discussion about this, dating back a couple of years.  The change was made a year ago, to comply with Google's enhanced security requirements.

Factory-reset your device, and make sure it is at the current software version ( http://fw.obihai.com/OBi-latest.fw ), then you should be able to add it to the portal again.

kliu888:
I must have factory-reset it 20 times. As soon as I dial **5 xxxx it reboots. I download the latest firmware and tried to upgrade but it says what I downloaded is identical to what's on the device so it won't update the firmware (guess that means I've already have the latest firmware). Is there another way to add it to the portal?

Navigation

[0] Message Index

[#] Next page