how to set up nomorobo with obihai obitalk google voice?
zorlac:
Quote from: Taoman on March 06, 2017, 03:30:00 pm
And the X_InboundCallRoute for your 2 GV trunks is what???????
Change X_InboundCallRoute for your 2 GV trunks to be:
ph,sp3(1866732xxxx@tollfree.alcazarnetworks.com;ui=$1)
Is Anveo being used for E911 only?
Changed SP1 & 2 X_InboundCallRoute to below and now it works.
X_InboundCallRoute ph,sp4(1866732xxxx@tollfree.alcazarnetworks.com;ui=$1)
I only use SP3 Anveo for 911 & as a failsafe if GV stops working.
So far Anveo hasn't had any SPAM yet so I'm leaving it alone.
It was so long ago that I guess I forgot that SP1 & @ 2 were changed too.
Thanks for persevering with me! ;D
Taoman:
Quote from: zorlac on March 06, 2017, 04:00:26 pm
It was so long ago that I guess I forgot that SP1 & @ 2 were changed too.
There is no point in changing X_InboundCallRoute on SP4............unless you're planning on getting a lot of inbound spam calls on a dummy trunk.
And for that matter you didn't even need to make the dummy SIP trunk on SP4 since you already had a working SIP trunk on SP3 you could use.
SteveInWA:
tf.arctele.com stopped working for me, too. The OBi shows:
Code:
...three "Ringing" attempts, then...
Call Failed (503 UNAVAIL Route Advance -9902; SP1(1866xxxxxxx@tf.arctele.com:5060;ui=1425xxxxxxx))
I changed to alcazarnetworks and that works fine (call from non-Spam number shown going to busy as it should):
Code:
Call Failed (486 Busy Here; SP1(186xxxxxxx@tollfree.alcazarnetworks.com;ui=1425xxxxxxx))
Sheesh, this is getting to be like "whack-a-mole".
Shinelikethunder:
First, I think one of the early posts contains a serious error that's repeated in quotes of that post:
{>ph,sp1(1866732xyzx@sip.tollfreeproxy.com;ui=$1)}
I had no success until I removed the ">".
Second, verification with Nomorobo should work if the configuration is correct and the proxy is working. Tollfreeproxy.com didn't work for me. Examining the call history, it's necessary to verify not only that the fork is done, but also that that line rings. You should see an entry like:
"Ringing (SP3(1877xxxxxxx@switch.starcompartners.com;ui=1631555xxxx))"
vo1paddict:
I was trying to follow this tutorial but I can't get my SP1 service to save the config.
My current X_InboundCallRoute is set up for use with FreePBX so it reads
Code:
SP3(NUMBER)
I tried updating it to Code:
SP3(212212wxyz),SP4(1877659wxyz@switch.starcompartners.com;ui=$1)
But it always reverts back to the old one, same when i did a manual edit of the xml and uploaded it.
UPDATE
My mistake was setting it on the device while it was being overwritten by obitalk, set it on obitalk and passed nomorobo test
Navigation
[0] Message Index
[#] Next page
[*] Previous page