"Emergency Service Call Routes to:" Add the number yourself
kccasey:
I know what the local 10 digit phone number would be if I dialed 911.
I would like the ability to input this information myself. Of course the Same disclaimer should be provided that 911, e911, etc would not be guaranteed or provided, like the disclaimer that is provided when you setup a GV number. Obviously, it would not be anyones responsibility or liability if a user enters in the wrong information. I would just like the ability to input this info myself.
As a way around, I've programed the number as speed dial 91. close enough I figured. however, as a human being, I'm already wired up to automatically dial 911 for an emergency.
azrobert:
Physical Interfaces -> Phone Port
Add the following to the beginning of the OutboundCallRoute
{(<911:8005551212>):sp1},
Change 8005551212 to your emergency number.
The above will remove 911 and replace it with 8005551212.
Use OBi Expert to make this change.
kccasey:
Just to be clear with your instructions, you mentioned to add to the BEGInning of the outboundcallroute. So just add to it, don't delete any other scripts that are already populated in that field?
Also, I have the Obi200, which has 2 phone ports. I'm assuming I should add this string to both ports?
azrobert:
Don't delete anything, just add the code like I said.
The OBi200 only has 1 phone port.
You must have an OBi202 and you must add the code to both phone ports.
kccasey:
SSorry, I do have the 202.
Navigation
[0] Message Index
[#] Next page