OBI100 Won't ring

<< < (2/2)

azrobert:
Is your phone plugged directly into the OBi100 or are you going thru your house wiring? If you are using the house wiring, connect the phone directly to the OBi100.

You can check the phone port voltages by logging into OBi Expert and going to Status -> Phone Status
Here are the voltages on my OBi110:

Idle:
Loop: 0mA
VBat: 57V
TipRing: 45V

Ringing:
Loop: 1mA
VBat: 76V
TipRing: 11V

These voltages will vary by a couple of volts
Make sure you click on Phone Status when the phone is ringing and not on the silence part of the ring pattern.

I never increased the ring voltage, so I don't know if it will help. You can do it using OBi Expert here:
Physical Interfaces -> Phone Port -> RingVoltage
Max setting is 82

If everything fails, try a factory reset using a paper clip.

ITpenguin:
Quote from: azrobert on September 15, 2015, 01:09:26 pm

Is your phone plugged directly into the OBi100 or are you going thru your house wiring? If you are using the house wiring, connect the phone directly to the OBi100.

You can check the phone port voltages by logging into OBi Expert and going to Status -> Phone Status
Here are the voltages on my OBi110:

Idle:
Loop: 0mA
VBat: 57V
TipRing: 45V

Ringing:
Loop: 1mA
VBat: 76V
TipRing: 11V

These voltages will vary by a couple of volts
Make sure you click on Phone Status when the phone is ringing and not on the silence part of the ring pattern.

I never increased the ring voltage, so I don't know if it will help. You can do it using OBi Expert here:
Physical Interfaces -> Phone Port -> RingVoltage
Max setting is 82

If everything fails, try a factory reset using a paper clip.


Factory reset fixed the problem... Strange that it would just stop working out of the blue, Thank you very much for your help i really appreciate it.

steveken:
I had the same problem as you, IT. Glad I found this thread or else I would still be working on it. LOL

Navigation

[0] Message Index

[*] Previous page