One GV Account and a Obi100 and Obi200

(1/3) > >>

bulbous:
Hi

I'm sorry if this has been covered but I am unable to find a solution.

I have two buildings on my property the main house I have set up my Obi200 and in the outhouse I have my Obi100. When someone calls me I would like both to ring but only the Obi200 rings. I can make out going calls on both fine. They are both connected to the same internet connection and router.

Many Thanks

azrobert:
Assuming GV is defined on SP1 of the OBi200

OBi200

Voice Services -> SP1 Service -> X_InboundCallRoute: ph,pp(200xxxxxx)

Change 200xxxxxx to the OBi number of the OBi100

OBi100

Voice Services -> OBiTalk Service -> InboundCallRoute: ph
The above is the default. I included this in case it was changed.

Use OBi Expert to make these changes

SeanyBoyUK:
I have a similar requirement to this but with 2 OBi100s on a generic SIP.

After following the instructions you have provided, calling my number results in the OBi Attendant answering after 2 rings.

Any suggestions welcome.

Thanks

azrobert:
Your situation is different than the above. The OBi200 will always receive the inbound call. In your case the last OBi100 to register to GV will receive the call. Make both of the above changes in the 2 OBi100s. This way it doesn't matter which OBi100 receives the call. Be sure you make the change to the OBiTalk Service InboundCallRoute. There is a rule in the InboundCallRoute sending the call to the AA.

SeanyBoyUK:
Perfect thank you

Navigation

[0] Message Index

[#] Next page