One GV Account and a Obi100 and Obi200
sidesrob:
Working on this solution, but when I go to Expert Setup "X_InboundCallRoute:" it looks like this: {('rob.sides'):aa},{ph1,ph2} and does not allow changes. What am I missing here?
I just set up the same GV numbers on both my OBi100 and OBi202 and both ring when called, however both units are on the same network presently. Will they both ring when I move one unit to another location?
Quote from: azrobert on September 18, 2015, 10:46:42 pm
Assuming GV is defined on SP1 of the OBi200
OBi200
Voice Services -> SP1 Service -> X_InboundCallRoute: ph,pp(200xxxxxx)
Change 200xxxxxx to the OBi number of the OBi100
OBi100
Voice Services -> OBiTalk Service -> InboundCallRoute: ph
The above is the default. I included this in case it was changed.
Use OBi Expert to make these changes
azrobert:
Quote
Working on this solution, but when I go to Expert Setup "X_InboundCallRoute:" it looks like this: {('rob.sides'):aa},{ph1,ph2} and does not allow changes. What am I missing here?
You need to uncheck both boxes to the right of the value then you will be able to change it.
Use the following X_InboundCallRoute:
{('rob.sides'):aa},{ph1,ph2},pp(200xxxxxx)
Quote
I just set up the same GV numbers on both my OBi100 and OBi202 and both ring when called, however both units are on the same network presently. Will they both ring when I move one unit to another location?
I don't know how it's working without my modification, unless something has changed with the firmware since I tested this. It shouldn't matter if the 2 boxes are on the same or different networks.
sidesrob:
Thanks for the prompt response! Will test without your modification when I get to other location.
sidesrob:
Quote from: sidesrob on December 20, 2015, 07:58:36 am
Thanks for the prompt response! Will test without your modification when I get to other location.
AAARRRGGHH! Got to other location only to discover Obi200 had it's power cut off. At new location I can make calls from my Obi100, but cannot receive. Will making the changes you specify above to my Obi100 rectify that?
azrobert:
I have a typo in my above response. It should be:
{('rob.sides'):aa},{ph1,ph2,pp(200xxxxxx)}
Navigation
[0] Message Index
[#] Next page
[*] Previous page