I need a dial plan for local #'s without having to dial the area code?

<< < (2/3) > >>

azrobert:
If you are using the local interface to configure your OBi200, use the same instructions as I posted. The only difference is you click on General tab separately.

equipped:
Okay, but instead of 1axxxxx, I only see 1xxxxx, no "a"  I have attached a screenshot of my Config page.  Thanks!

azrobert:
This is the default DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)

Change it to:
(<1480>xxxxxxx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.)

Now when you dial a 7 digit number the dialplan will prefix the number with "1480". Change "480" to your local area code. I removed a couple rules that are not needed.

equipped:
Thanks so much.  I am guessing that when I need to dial a real long distance number out of our area code, I just dial "1-Area Code" then the number? 

azrobert:
You can also just dial 10 digits. Rule <1>[2-9]xxxxxxxxx will prefix a 10 digit number with a one.

Navigation

[0] Message Index

[#] Next page

[*] Previous page