News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

[BUG REPORT] 1032 & 1062 do not apply line key details from expert config

Started by Marc, October 03, 2015, 11:37:59 AM

Previous topic - Next topic

Marc

Model: OBi1032 & OBi1062
Firmware: 5.0.0 (2860.1311)
HW Version: 1.3

Since there is no way to configure the line keys, past the 3 displayed on tab 1, without going into expert config... I have done that and configured line key 4,5 & 6 to correspond to SP4, SP5, & SP6.  While the service setting is accepted and applied, the number and name settings are not.

I have found the only way to change them is directly on the phone itself.

Has anyone found a way to configure line keys 4 and up on the 1032, or for that matter, line keys 7 and up on the 1062, from the obitalk default web interface or to get the settings from expert mode to be applied?

Thank you.
OBi110 (stored in closet now,) OBi200 x 3, Polycom 200 x 1, OBi202 x 4, Polycom 202 x 2, OBi1032 x 3, OBi1062 x 5, OBi2182 x 3

Combination of GV (consumer,) CallCentric & voip.ms both direct and via Asterisk.

xdreamwalker

Did you ever figure this out? I have a new OBi1032 and in the Expert Settings added SP4 to line key 4, I even changed the name/number, but it doesn't show correctly on the phone. I haven't figured out how to change the name/number directly on the phone either.

xdreamwalker

I think I figured it out. My OBi1032 would not accept the information in the Expert Settings for "IP Phone - Line Keys" however the line key on my phone did respond to me changing "Voice Services - SP4"

I changed the X_DisplayLabel and X_DisplayNumber. The values I entered there changed the line key display on my phone.