Cannot add device in obitalk

(1/3) > >>

igmic:
I cannot add my obi110 to my obitalk. dialing **5 1234 gives "invalid number". it seems that my obi110 isn't connected to the internet or the "phone" port is dead as there is no tone unless i connect the line to my wall.

dialing ***1 also gives invalid number. good thing a static dhcp is reserved by my router and i was able to use the wizard to configure google voice as my sp1. unfortunately, it doesn't ring when being called. it is also unable to place outgoing calls. call history is being recorded though.

yhfung:
You have to confirm your settings are okay by calling the ObiTalk Echo Test number 222 222 222 with the following dialling key sequence.

**9 222 222 222.

YH

igmic:
^ it does not work.
It seems that my unit is unable to connect to the internet. I have tried bypassing the router by connecting the Obi directly to my modem (which handles pppoe). I still don't get a dial tone.

M105:
Static DHCP?  Either you have it set for a static address or you are using DHCP with the router assigning an address.  Which is it?

Can you reach the Internet on a computer plugged into the same ethernet port on the router?  Disable the wireless adapter on the computer and make sure you can reach the Internet with a cabled connection only.  If not you have a router config problem.  If so, try resetting the Obi to factory defaults and dialing the test number.

M105:
Also...try a different telephone.

Navigation

[0] Message Index

[#] Next page