New Obi202 setup with Anveo911 and Ring.To - Unable to proceed error

<< < (2/2)

BGood:
Update:  It has been 7 days since initiating the Comcast > RingTo port request through the RingTo website.  As advised, I gave up on attempting to initiate the port from the Obitalk portal.

On day 2, I received an email from RingTo stating "We just wanted to let you know that your number port has been approved and the process will begin on 12-07-2015 11:30 AM EST. You will receive a confirmation email once your phone number is fully activated in RingTo".

On day 7 (today), I received another email from RingTo stating "Congratulations, your personal number is now active on RingTo. Be sure to log in and configure your number for forwarding or customize your outgoing message."  Which I did.

Now, I am still getting dial tone through the Comcast modem, and can make but not receive calls on the ported number.  I assume that the next step is to configure SP1 on the OBI202 for RingTo service.  Given my recent experience with the broken integration between the Obitalk and RingTo websites, I am not sure whether to use Obitalk's automated configuration wizards or attempt to manually configure the SP1 port on the Obi202.  The configuration status is as follows:

[img src=Obi202Config.jpg][/img]

What are the next next steps to get the ported RingTo line working?  Thanks.

BGood:
Follow-up...

From reading other posts in the forum, I surmised that I needed to: 1) delete RingTo provisioning from SP1; then 2) reassign RingTo provisioning on SP1.  After doing this, I can now initiate and receive calls on the Obi202.  The Obi202 configuration now appears as follows:

[img src=Obi202Config-2.jpg][/img]

The next steps for me will be to provision my Google Voice line on the Obi's Phone2 port.

Thanks for everyone's assistance in the process.

Navigation

[0] Message Index

[*] Previous page