Just got a 202, $10.00 Hostage to use google voice ? Please help
transam98:
My appologies yes I DID crosspost ;( again sorry...
transam98:
So I got it !! Thanks to Those who helped !! :) (and those that didnt indirectly)...
Hostage crisis over (lol)... Saved me $10 :) eeheh
I know this is off subject from the above....
But can someone direct me:
I know there is Two RJ11(or is it 12)'s....
on "Line 1" the inner TWO leads I want to be SP1 (the standard)
then on Line 1 the TWO outer leads I want to RUN to a COMPLETELY different phone and use that as SP2
and then on LINE 2 Jack the inner two I wanna go to another phone (SP3) and the outer TWO on LINE TWO I wanna have that goto SP4, is that possible ? Ive got 4 DIFFERENT google voice accounts that is possible right ?
Can someone point me to HOW Id configure them ports like that assuming its the standard ? (remember I do have a Obi202) thanks again for the community support !
SteveInWA:
Quote from: transam98 on December 03, 2015, 04:21:25 pm
So I got it !! Thanks to Those who helped !! :) (and those that didnt indirectly)...
Hostage crisis over (lol)... Saved me $10 :) eeheh
I know this is off subject from the above....
But can someone direct me:
I know there is Two RJ11(or is it 12)'s....
on "Line 1" the inner TWO leads I want to be SP1 (the standard)
then on Line 1 the TWO outer leads I want to RUN to a COMPLETELY different phone and use that as SP2
and then on LINE 2 Jack the inner two I wanna go to another phone (SP3) and the outer TWO on LINE TWO I wanna have that goto SP4, is that possible ? Ive got 4 DIFFERENT google voice accounts that is possible right ?
Can someone point me to HOW Id configure them ports like that assuming its the standard ? (remember I do have a Obi202) thanks again for the community support !
The OBi 202 has two Phone jacks, called Phone 1 and Phone 2. Phone 1 is wired in RJ-14 configuration: it has line 1 on the center two pins, and line 2 on the outer two pins. Phone 2 is wired in RJ-11 configuration: it has line 2 on the center two pins, and no connection on the outer two pins.
The logical routing of service providers to Phone port jacks is controlled on the OBiTALK portal, when you set up each service provider.
transam98:
Thanks for the reply steve, Is it not possible to make SP3 and SP4 use the "Line 2" jacks or is just SP3 and SP4 (Sip provider?) are a software thing that will roll into the LINE 1 jack ? thanks :)
SteveInWA:
I don't understand your question, but you can route inbound calls to any SP to either or both Phone jacks. For example, on my 202, I route SP1 to Phone 1, and SP2, SP3 and SP4 all to Phone 2. You can similarly control which SP is used by which Phone jack for outbound calls. It's all on your portal page, configured on a per-SP basis.
Navigation
[0] Message Index
[#] Next page
[*] Previous page