Call hunt with two obihai 202 devices
azrobert:
Strange. I don't know why Forward on No Answer would cause a problem.
You can route the call back out Phonepower to GV. I assume you don't want to use Ring.to. Phonepower will have to support simultaneous inbound and outbound calls. GV will see the Phonepower callerid, not the inbound callerid. You can block the Phonepower callerid on SP2 from ringing.
SP1 Service X_InboundCallRoute: ph,sp1(GV_Number)
To be safe, increase the max sessions:
SP1 Service MaxSessions: 4
SP2 Service X_InboundCallRoute: {Phonepower_callerid:},{ph}
You need to use an 11 digit callerid.
There is a colon after the callerid.
Volta10:
Quote from: azrobert on December 13, 2015, 05:33:00 pm
OBi202#1
Voice Services -> SP1 Service
X_InboundCallRoute: ph1
CallForwardOnBusyEnable: Checked
CallForwardOnBusyNumber: sp4(fwd@127.0.0.1:5063)
CallForwardOnNoAnswerEnable: Checked
CallForwardOnNoAnswerNumber: sp4(fwd@127.0.0.1:5063)
"Voice Services" and "SP1 Service" corresponds to the tabs on the left side of the OBi Expert page.
Click on Voice Services then click on SP1 Service
Now change the parms.
Both boxes to the right of the value must be unchecked to be able to make changes.
After all changes are complete for this page, click Submit and wait until the OBi202 reboots.
Now do the same for the following:
Service Providers -> ITSP Profile D SIP
ProxyServer: 127.0.0.1
X_SpoofCallerID: Checked
Voice Services -> SP4 Service
AuthUserName: OBi202a
X_RegisterEnable: unchecked
X_ServProvProfile: D
X_InboundCallRoute: ph2
CallForwardOnBusyEnable: Checked
CallForwardOnBusyNumber: pp(510222222)
CallForwardOnNoAnswerEnable: Checked
CallForwardOnNoAnswerNumber: pp(510222222)
Change 510222222 to the OBi number of OBI202#2
Physical Interfaces -> Phone 1 and Phone 2:
CallWaitingEnable: Unchecked
OBi202#2
Voice Services -> OBiTalk Service
InboundCallRoute: ph
CallForwardOnBusyEnable: Checked
CallForwardOnBusyNumber: ph2
CallForwardOnNoAnswerEnable: Checked
CallForwardOnNoAnswerNumber: ph2
Physical Interfaces -> Phone 1:
CallWaitingEnable: Unchecked
Edit:
Disable call forwarding in Phonepower.
Hi, it's been over a year since I last used this option. Now I want to use it again but it's not working for me :(
I followed the direction as above (except I no longer want call forward on no answer. I just want call foward on busy) and this is how my phone behaves:
I just want to remind that I have a 4 line phone with obihai 202a connects to lines 1,2 and obihai 202b connects to lines 3,4.
1) When someone talking on lines 1,2 and a third caller calls in nothing happens. It rings until the voicemail kicks in.
2) When lines 1,2 are on dial tone (but no active phone calls are being made) and a third caller calls in then it will promptly rings line 3 off obihai 202b device.
I have tried this with phonepower and callcentric and they both behave the same way. Am I doing something wrong? Clearly it worked for me in the past but not anymore. Thanks in advance for the help.
Navigation
[0] Message Index
[*] Previous page