Obi100 No inbound calls, outbound works fine
pbd3mon:
Thank you for the suggestions, I do see the inbound issues listed on the site so I finally submitted a ticket but my guess is since the echo test worked just fine they'll tell me the DID is working properly on their end. Worth a shot though. When I find some free time I will try X-Lite.
Thanks guys.
pbd3mon:
Hmm I got a reply from voip.ms and apparently the server IPs were changed I had the old one in my settings. After updating the IP everything is back to normal. It's kind of strange that the IPs were changed without any notifications... Anyhow thanks again, now I can rest. :D
SteveInWA:
Do you mean that you actually had the IP address, i.e. x.x.x.x in your configuration, instead of, for example, denver.voip.ms? It's usually best to not configure devices with IP addresses, since, as you found, they may change over time, causing these issues.
pbd3mon:
Yes I had actual IPs for the servers I use in my OBi settings Service providers menu >> ITSP Profile >> SIP >> at the "X_AccessList" option
I believe I did that in an effort to stop spam calls...I can't quite remember now.
pbd3mon:
Well this is not good, my OBi just reverted back to my old IPs after accepting the new one and rebooting, and incoming calls don't work again. Any reason it would do that?
I get this "Status Registered (server=158.85.70.150:5060; expire in 59s)" after changing IP and rebooting and when the timer runs out it goes back to old IPs. >:(
Navigation
[0] Message Index
[#] Next page
[*] Previous page