Allowed calls to 9** numbers

(1/4) > >>

deinck:
Hi -
I have a new 1022 and recently have added Aveo's 911 service.  I would like to dial their 933 to verify, but I don't seem to have something setup correctly :'(

For the ITSP Profile A General, I altered the DigitMap to:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|9xx(Mipd)|[^*#]@@.)

Does this need an edit or?


Thanks!

azrobert:
OBiHai processes 911 separately. To be consistent do the following:

You should have 911 in the Phone Port DigitMap
Change it to 911|933

You will also have {911:sp1} in the Phone Port OutboundCallRoute
Change it to {911|933:sp1}

By doing this you will also see if 911 was setup correctly.

Did you add 9xx to the ITSP A DigitMap?
Your mistake was not including the vertical bar separator.

933 still should have worked because it will match xx. but will have a 10 second delay.

deinck:
thanks azrobert, as you're always a great help!


So currently this is what I have for the  ITSP A DigitMap:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|911|933|(Mipd)|[^*#]@@.)
Yes, I had added the 9xx ...now edited to that 911|933...look OK?

What section is the Phone Port OutboundCallRoute in?



thanks!

azrobert:
Looks good.
Just make sure 911 in the Phone Port OutboundCallRoute is being routed to SP1.
If you want you can remove {911:sp1} from the OutboundCallRoute.
It can be found here:
Physical Interfaces -> Phone1/2 Port

deinck:
hmm, I don't seem to have a Physical Interfaces -> Phone1/2 Port unless I'm blind?  Attached is a screenshot (capture.png) of what I see.  Setup.png shows the device setup


Thanks!

Navigation

[0] Message Index

[#] Next page