Allowed calls to 9** numbers
deinck:
I get 'could not complete your call' error.
yes, primary line is SP1
azrobert:
That doesn't sound like an OBi1022 error message, so I think Anveo is rejecting the call. Check the call history to verify this.
To access Call History:
Log directly into the OBi1022 using the local interface.
Key the IP address of the OBi1022 into a Web Browser.
Hit Enter
The UserID and default Password are both "admin".
Click Status on the left column then click Call History.
It should show:
From PH1 To SP1(933)
Ringing
Call Connected
deinck:
Appears that its connecting (attached)
SteveInWA:
You have SP1 configured to use Google Voice, so the 9xx call is going out via Google Voice, which is, as designed, telling you it can't complete the call. This is shown in your reply #4.
This mess could have been avoided if you had simply used the OBiTALK portal to set up the two service providers, vs. all that digit map editing.
deinck:
Both the gVoice (sp1) & Aveo 911 (sp2) were auto-config'd when first setup, but SP1 still failed to call out on any 9**, # hence the perceived digit map edits required & even Aveo support stated so. I would have loved for it to be simpler for sure. If you're certain I can leave well enough alone, what's now stopping me from just again selecting the default checkbox in the expert interface then if it will all work as you state the portal will do it all just right?
thanks to both!
Navigation
[0] Message Index
[#] Next page
[*] Previous page