Conflict with OBi * codes and Phone Power * codes
Taoman:
Quote from: cracker on January 19, 2016, 05:43:43 pm
Phone Power is registered on SP1 and the Primary Line on Phone Port 1 is "SP1 Service"
To try to call forward I dial *72nnnnnnnnnn#. To clear call forwarding I dial *73#.
Hmm. That is exactly what I'm doing and it works fine. What happens when you try this? Do you hear an error message of any kind?
cracker:
No messages. When I do *72... I get 1 or 2 low pitched beeps and then a higher frequency beep. When I do *73... I get a busy signal.
cracker:
When I modify the digit map, neither the device default box or the OBiTalk box is checked. Is that correct?
Taoman:
Quote from: cracker on January 19, 2016, 05:55:35 pm
No messages. When I do *72... I get 1 or 2 low pitched beeps and then a higher frequency beep. When I do *73... I get a busy signal.
But you are sending the entire string (*72nnnnnnnnnn#) all at once, right?
Correct, both boxes should be unchecked.
Just for fun replace the string you added to your digit map with the following which includes checking voicemail:
*21|*72|*73|
cracker:
I don't send the string, using a touch tone phone I just dial the numbers.
I'll try adding *21. (*21 does work now to access vm)
Navigation
[0] Message Index
[#] Next page
[*] Previous page