obi202 behind a EdgeRouter Lite with ObiTalk.com
rokkett:
I am attempting to set up an obi202 behind an EdgeRouter Lite.
The obi202 is running the latest firmware:
HardwareVersion 1.4
SoftwareVersion 3.1.0 (Build: 5110)
The EdgeRouter is running version 1.7.0 of the firmware.
The **9 222-222-222 echo test server call works as expected.
When I attempt to add a new device, the ObiTalk site never acknowledges the device registration.
I turned on sysloging and see nothing logged during the registration process.
Feb 6 16:28:51 obi202 si3226x : Channel 0 : Chip Rev 3
Feb 6 16:28:51 obi202 si3226x : Channel 1 : Chip Type 28
Feb 6 16:28:51 obi202 si3226x : Channel 1 : Chip Rev 3
Feb 6 16:28:51 obi202 PARAM Cache Write Back(256 bytes)
Feb 6 16:28:51 obi202 ==== Networking is ready ====
Feb 6 16:28:51 obi202 IP Address= 192.168.1.30
Feb 6 16:28:51 obi202 Gateway = 192.168.1.1
Feb 6 16:28:51 obi202 Netmask = 255.255.255.0
Feb 6 16:28:51 obi202 Patch verification passed, and enable patch
Feb 6 16:28:51 obi202 Patch verification passed, and enable patch
Feb 6 16:28:52 obi202 VBAT Up = 58.901 v
Feb 6 16:28:52 obi202 VBAT Up = 58.272 v
Feb 6 16:28:52 obi202 PARAM Cache Write Back(256 bytes)
Feb 6 16:28:53 obi202 Starting LB Cal on channel 0
Feb 6 16:28:53 obi202 Starting LB Cal on channel 1
Feb 6 16:28:55 obi202 ProSLIC_RingSetup : VBATR_EXPECT (5500000): Clamped to Gen Conf Limit (51eb82a)
Feb 6 16:28:55 obi202 Si3226x PCMStart
Feb 6 16:28:55 obi202 ProSLIC_RingSetup : VBATR_EXPECT (5500000): Clamped to Gen Conf Limit (51eb82a)
Feb 6 16:28:55 obi202 Si3226x PCMStart
Feb 6 16:28:56 obi202 Random Delay Range: 30
Feb 6 16:28:56 obi202 Actual Randome Delay: 10
Feb 6 16:28:56 obi202 Setup Provisioning for system start! 10
Feb 6 16:28:56 obi202 PROV: Lua update checksum not configured.
Feb 6 16:28:59 obi202 [BT#0] BT_EVT_BT_DOWN @ 485
Feb 6 16:28:59 obi202 [BT#1] BT_EVT_BT_DOWN @ 485
Feb 6 16:28:59 obi202 PROV: SNTP clock is ready
Feb 6 16:28:59 obi202 PROV: Timers adjusted according to SNTP clock
Feb 6 16:29:07 obi202 PROV: Starting provisioning process
Feb 6 16:29:07 obi202 PROV: Start to download files ...
Feb 6 16:29:07 obi202 PROV: Invalid server name, Skipped
Feb 6 16:29:07 obi202 PROV: schedule the next provisioning process
Feb 6 16:47:24 obi202 PARAM Cache Write Back(256 bytes)
I even added 4.2.2.2 as a DNS on the obi202, no change.
On the EdgeRouter, I have disabled the SIP module:
set system conntrack modules sip disable
I have enabled the upnp service:
set service upnp listen-on eth0 outbound-interface eth1
At one point, I have even set up port forwarding for the following ports back into my network for the obi202:
5060
5061
10000-20000
But still no success.
Thoughts?
rokkett:
Just a quick update. I will be returning this device. I connected it directly to my cable modem with no firewall/router etc blocking any traffic and still unable to register it ObiTalk.com.
Does comcast block these devices from their network? Nothing on my end that I can control is blocking this device from functioning correctly.
Oh, well. It sounded like a great idea. Moving on to other devices after more research...
rokkett
Sheffield_Steve:
I have a similar setup: Edgerouter, Comcast, etc and it all works perfectly without any special setup. Maybe you have a bad obi202?
rokkett:
When you say "no special setup", do you mean you didn't make any SIP or upnp settings? I started that way and just kept reading and trying settings to resolve my issue.
The echo test always works.
Odd...
Sheffield_Steve:
That's correct! No SIP or upnp settings, just the basic config via the wizard.
Quote from: rokkett on February 07, 2016, 01:37:23 pm
When you say "no special setup", do you mean you didn't make any SIP or upnp settings? I started that way and just kept reading and trying settings to resolve my issue.
The echo test always works.
Odd...
Navigation
[0] Message Index
[#] Next page