How to answer incoming VoIP calls to L1 with cell phone using OBIBT on OBI202

[BobMarkinson]

Hello everyone,

I need some help from the community to figure this one out. I am using the FreePhoneLine VoIP service with my Obi202. It works beautifully and I have zero problems.

I just got a OBIBT bluetooth adaptor and it's paired to my iPhone. I can make calls with the home phones through the cell phone using the **8 prefix. Also, when someone calls my cell, the home phones ring and I can answer. It works beautifully.

What I can't figure out is when someone calls my VoIP service on L1,  and the Home phones ring, how do I answer with my cell phone?   It shows as paired but nothing happens when I receive a call on the VoIP service.  I also can't seem to figure out how to use my cell phone to dial out through L1 on the Obi202.

I have looked everywhere and read all the documentation. Can someone help?

[azrobert]

I don't think you can do what you want using OBiBT. You will need to install a softphone on your iPhone. Zoiper is a free softphone. You then register the softphone to the OBi202 and now you will be able to route calls to/from your iPhone. Use OBi Expert to make the following changes:

OBi202:
Service Providers -> ITSP Profile D  SIP -> ProxyServer: 127.0.0.1
Service Providers -> ITSP Profile D  SIP -> X_SpoofCallerID: Checked
Voice Services -> SP4 Service -> AuthUserName: OBi202
Voice Services -> SP4 Service -> AuthPassword: password
Voice Services -> SP4 Service -> X_RegisterEnable: Unchecked
Voice Services -> SP4 Service -> X_ServProvProfile: D
Voice Services -> SP4 Service -> X_Proxy: Checked 
Voice Services -> SP4 Service -> X_InboundCallRoute: {OBi202>(Msp1):sp1}

Voice Services -> SP1 Service -> X_InboundCallRoute:
ph,ph2,sp4(OBi202@xx.xx.xx.xx:5060)

xx.xx.xx.xx is the IP address of the iPhone
5060 is the port number of Zoiper

Zoiper:

Proxy: yy.yy.yy.yy:5063
UserID: OBi202
Password: password

yy.yy.yy.yy is the IP address of the OBi202
5063 is the X_UserAgentPort of OBi202 SP4 trunk
The Zoiper default is to assign a random port
You need to set the SIP port to 5060
Go to Config -> Connectivity -> Listening Ports
Under Local SIP Port uncheck Random Port
The port number should be 5060
If it's not change it to 5060

[drgeoff]

I'll confirm what azrobert thinks. The OBiBT cannot enable SIP, GV or POTS calls through an OBi ATA to be initiated or answered on a cellphone.

That an ObiBT cannot do what is desired here is not down to Obihai. Bluetooth on a phone does not have the required functionality.