callcentric related
earthtoobi:
Made the change. get an engaged tone(not that the number is engaged.it does not show in obi/callcentric history).
RonR:
You must have a typo somewhere, as it works here.
With:
|*<00:75>xx|
as a DigitMap rule and
{(*75xx):sp2},
as an OutboundCallRoute rule, dialing *0033 sends *7533 out SP2.
The ITSP I have on SP2 doesn't particularly like it, but it goes out as expected. :)
earthtoobi:
is the digitmap phone port or ITSPB(primary line) digitmap
RonR:
Technically, it's all one. The ITSPB DigitMap is an extension of the PHONE Port DigitMap. Normally, we don't make changes to the top-level PHONE Port DigitMap, but rather to the subordinates it references (ITSPB, for example).
PHONE Port -> DigitMap:
([1-9]x?*(Mpli)|[1-9]|[1-9][0-9]|911|**0|***|#|**1(Msp1)|**2(Msp2)|**8(Mli)|**9(Mpp)|(Mpli))
ITSPB (used by SP2) gets referenced whenever you dial **2 [**2(Msp2)], or through (Mpli) when you don't dial **2 [(Mpli) is replaced by (Msp2) when PrimaryLine is set to SP2 Service].
I had |*<00:75>xx| in ITSPB.
earthtoobi:
must be a typo..since i got it to work after changing everything back to original and putting in the changes afresh..Thanks Ron..
Now when we combine this setting to the single stage dialing setup that you mentioned:
then
wouldn't the first line of Obitalk Inbound Call route Route: (Mcot)>(Mpli_sp2_in_my_case):pli_sp2_in_my_case
Match because we have made changes to the last line in the digit map of sp2: [^*]@@ and route through SP2 - which is not what we want.
Navigation
[0] Message Index
[#] Next page
[*] Previous page