2 GV #'s on OBI 200
Dbrown25:
Hello,
I have a OBI200 and a 2 line phone that I only need to make outgoing calls on from the second line. I don't need it to ring or receive incoming calls or bridge up a 3 way, just strictly to dial out on.
Example: Line 1 caller on hold while dialing out to another party on line 2
Is this possible with my current config?
Everything is running perfectly.
Thanks!
D
N7AS:
If your outgoing line is on SP2 then:
Voice Services > SP2 Service > X_InboundCallRoute set to {}
Your Line 2 will not ring.
drgeoff:
An OBi200 has a single phone port which is wired for a 1-line phone. You cannot use the 2-line functionality of a 2-line phone.
You can use a single line of the phone to put a call on hold and make another call. Usually by hook flashing. Search for 'Handle Hook Flash Locally' in http://www.obihai.com/OBiDeviceAdminGuide
N7AS:
Quote from: drgeoff on April 21, 2016, 01:46:17 pm
An OBi200 has a single phone port which is wired for a 1-line phone. You cannot use the 2-line functionality of a 2-line phone.
You can use a single line of the phone to put a call on hold and make another call. Usually by hook flashing. Search for 'Handle Hook Flash Locally' in http://www.obihai.com/OBiDeviceAdminGuide
What was I thinking? Well at least SP2 will not ring.
Lavarock7:
Quote from: N7AS on April 21, 2016, 02:00:05 pm
Quote from: drgeoff on April 21, 2016, 01:46:17 pm
An OBi200 has a single phone port which is wired for a 1-line phone. You cannot use the 2-line functionality of a 2-line phone.
You can use a single line of the phone to put a call on hold and make another call. Usually by hook flashing. Search for 'Handle Hook Flash Locally' in http://www.obihai.com/OBiDeviceAdminGuide
What was I thinking? Well at least SP2 will not ring.
In fact SP86 will also not ring. However, if you want 86 to initiate a call, he has to remove his shoe...
Navigation
[0] Message Index
[#] Next page