I cant hear other party
Payam:
i was able to telnet. but then the command line starts with ras. where should I type ip nat service sip active 0
?
i dont see any menu option
Payam:
the valid commands are:
sys
ip
lan
bridge
other
wan
qos
certificates
Payam:
I went to modem interface and I see that SIP ALG box is unchecked. So may be the problem is somewhere else
Payam:
I am out of any idea what else I can do. I still have the problem that I cant hear the other party although the SIP ALG is disabled. I rebooted the OBi device. I deleted my phone and I added it again. Can anybody help me here
Thanks
ianobi:
If the call is set up ok and the problem is one way speech, then the problem is likely to be the RTP ports being used. RTP is used to transport speech.
Try putting the OBi100 into DMZ of your router. If this works, then take it out of DMZ and port forward in your router the relevant RTP ports. In your OBi100 look under Service Providers > ITSP Profile A (for sp1) > RTP to see which ports are used for RTP.
Navigation
[0] Message Index
[#] Next page
[*] Previous page