OBI100 says need firmware update to use GV, but already using latest version
daytradder:
Quote from: yorktown on May 18, 2016, 09:37:23 pm
This is worked for me, thanks yorktown ... make sure to reconfigure your device in "Device Configuration"
Found the solution on another thread for the Obi100.
Download this firmware for the Obi110 http://fw.obihai.com/OBi110-1-3-0-2886.fw
(Yes, I know its for the Obi110 but it will work in the Obi100).
Then Reboot.
If you don't know how to install the firmware:
Dial * * * 1
It will give you the IP Address: 192.168.XXX.XXX (example 192.168.1.27 )
In your browser, enter the IP Address as the URL.
User Name: admin
password: admin
On the left side, navigate to SYSTEM MANAGEMENT
Click DEVICE UPDATE
At the top where it says "Firmware Update
Select file to update firmware [BROWSE] ...."
Click BROWSE and add the file. Then click UPLOAD
Once it reboots its done.
In the obitalk portal, you can delete the old device and add a new device. Its should work with Google Voice using OAuth.
lucy1012:
***1 cant get IP address
**9 222 222 222
is good .
heard:"no service in your area log on obitalk.com"
FormerYooper:
No service this morning with Obi100 with current firmware in place. Tried to make a call & was told to log into Obitalk. When I did, it says OBi now longer supports this device and I need to reconfigure it. GV on SP1 and Callcentric on SP2. I have tried 3 times unsuccessfully to reconfigure. I even get a message on the top of the configuration page that GV was successfully configure and yet the message next to SP1 say Service NOT configured. What the heck is going on? If our OBi 100 is still in working order, why is OBi not allowing us to configure the device?
Edit/Update: This is BS. I have an OBi 200, so I just configured my services there!
Mango:
Double check that your firmware build is 2886. If not, perform a manual upgrade to 2886 and that should solve the problem. If it is already 2886, factory reset and reconfigure.
RaymondDay61:
Got mine working the OBi110. Did the firmware update "1.3.0 (Build: 2886)" then hold the button on the bottom of it for 15 sec. Went to obitalk.com and said to set up my Google voice again. But after a wile it error-ed and said to type on my phone some *** number. I did and my OBi110 reset it self about 5 times wile I went to set it up. I could hear a little click on it.
Went to set it up again on obitalk.com and it set up my SP2 and I seen my SP1 changed to "Connected" so I deleted the SP2.
I tested it out calling my cell phone and it works again.
So the Factory Reset button seems to fix it.
-Raymond Day
Navigation
[0] Message Index
[#] Next page
[*] Previous page