Config for local calls via landline & long distance calls via Google Voice

(1/4) > >>

Darin:
I know there are several posts on this topic already but I'm reading conflicting (and seemingly very complicated) information on how to set up a simple outbound call filter on the Obi110. 

I have the analog PSTN line port (my landline) set as the Primary Line for outbound calls and SIP Service Provider 1 uses Google Voice. I understand 911 calls automatically route via the PSTN.

I simply want 10 digit numbers to route via the PSTN line port and everything else (11 digit numbers & 011 numbers) to route via Google Voice.

Thank you!

RonR:
Physical Interfaces -> LINE Port -> DigitMap:

([2-9]xxxxxxxxx|<**1>1xxxxxxxxxx|<**1>011xx.)

Darin:
Awesome! Works perfectly, thank you. However, we have new developments, as follows:

1. Would like 7 digit dialing via PSTN using 403 area code.
2. Would like all other calls to go over GV including 10 digit (other than 403), 11 digit & 011.

Thanks again.

RonR:
You can't dial a 7-dgit number and have the OBi read your mind as to whether you want that to be a 403 call via the PSTN or an 801 call via Google Voice.   :)

The following assumes 7-digit calls are for area code 403 via the PSTN.  You can dial **1 + a 7-digit number and 1 + 801 will be added before it's sent via Google Voice.


Physical Interfaces -> LINE Port -> DigitMap:

(<403>xxxxxxx|(403xxxxxxx|<**1>xx.)


Service Providers -> ITSP Profile A -> General -> DigitMap:

(<1801>xxxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|011xx.|(Mipd)|[^*]@@.'@'@@.)


          7-digits  ->  PSTN (403 + 7-digits)
403 + 7-digits  ->  PSTN (403 + 7-digits)

        10-digits  ->  Google Voice (1 + 10-digits)
        11-digits  ->  Google Voice (11-digits)
             011+  ->  Google Voice (011+)

ProfTech:
It sounds like your local area code is 403 and your PSTN provider requires 10 digit dialing for a local call. If this is correct, the settings below should give you the dialing you want without any need to press any extra digits like **1, etc. I am leaving the *** in there just in case you want or need to access the internal settings.

(911|***|#|(Mli)|(Msp1)) Phone port digit map

{(911|<#:>|(Mli)):li},{(Msp1):sp1},{***:aa2}} Phone port outbound call route

(1[2-9]xxxxxxxxx|<1>[2-9]xx[2-9]xxxxxx|[011]xx.)  ITSPA Digit Map

(<403>[2-9]xxxxxx) Line port digit map

If you dial 911 it will go to the PSTN [GV doesn't support 911]
Any time you dial 7 digits it will be sent out the PSTN as 403 + what you dialed [10 digits total]
Any time you dial "011 + anything", any 10 digits beginning with 2-9, or 11 digits beginning with "1" the call will be sent to Google Voice [ITSPA]

You can force a 403 call to go out Google Voice at any time simply by dialing 10 digits.

*Updated the ITSPA digit map to remove some ambiguity.

Navigation

[0] Message Index

[#] Next page