January 04, 2022, 10:35:19 am *
Welcome, Guest. Please login or register.
News:
 
   Forum Home   Search Login Register OBiTALK  
Pages: [1]
  Print  
Author Topic: Choosing and installing the right Obi  (Read 1525 times)
gatorling
Newbie
*
Posts: 2


« on: May 23, 2016, 06:52:04 pm »

I'm planning to buy an Obi but cannot place the Obi near the phone.

Is it possible and safe to connect the Obi to my router and then have a mail-mail phone cord connect the obi to my (inactive) landline network?

Does it work this way? or do I always need to have the phone connected directly into the Obi?

Thanks
Logged
N7AS
Hero Member
*****
Posts: 519



« Reply #1 on: May 23, 2016, 07:09:37 pm »

Yes, you can do it that way. Just be absolutely sure that your inside phone wiring is disconnected from the box outside your home.
Logged

Grant N7AS
Prescott Valley, AZ
https://www.n7as.com

A journeyman electrician sent his apprentice with a 5-gallon bucket and was told to put the ends of the service drop in the bucket and fill it with volts. He was there all day.
dircom
Sr. Member
****
Posts: 491


« Reply #2 on: May 24, 2016, 08:29:22 am »

you might use a regular telephone cord, instead of a mail-mail, fax-fax, or  Wink

Reiterate: go to the network interface and disconnect the inside house wires, from the incoming telco line !!
Logged
gatorling
Newbie
*
Posts: 2


« Reply #3 on: May 24, 2016, 03:30:37 pm »

So I assume that if I connect a phone to my house network and I do not hear a dial-tone then I am good...but for good measure I should go to where my home network connects to the utility drop and disconnect those wires?

Thanks everyone!
Logged
dircom
Sr. Member
****
Posts: 491


« Reply #4 on: May 24, 2016, 04:14:24 pm »

So I assume that if I connect a phone to my house network and I do not hear a dial-tone then I am good...but for good measure I should go to where my home network connects to the utility drop and disconnect those wires?

Thanks everyone!

No, you are not good if you don't hear a dial tone, it could still be connected to the cable outside.  Disconnect, Not for good measure, but to protect your in home network.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC

Advertisement
Advertisement