Obitalk and autodialer

<< < (3/3)

TerryaG:
SteveInWA:

I am doing that now, directly attached, and have removed the Y splitter.

I am trying tweeking the ChannelRxGain setting per drgeoff's previous suggestion, both up and down.  I am seeing some discrepancies in setting this value directly via the IP address of the device vs. the Advanced Config menu of Obitalk.com.  If I change the value on one page, they are not reflected on the other.  Looks like you have to initiate a reboot after changing values via the direct IP method?  Not clear.

If you read the previous threads you'd see that I tried contacting Control Products and they said that although it works with many/most VoIP methods, they don't provide support for it.  There are DIP switches, but none of them are in regards to dialing thresholds.


Thanks!

Terry

SteveInWA:
Quote from: TerryaG on June 07, 2016, 08:41:14 pm

SteveInWA:

I am doing that now, directly attached, and have removed the Y splitter.

I am trying tweeking the ChannelRxGain setting per drgeoff's previous suggestion, both up and down.  I am seeing some discrepancies in setting this value directly via the IP address of the device vs. the Advanced Config menu of Obitalk.com.  If I change the value on one page, they are not reflected on the other.  Looks like you have to initiate a reboot after changing values via the direct IP method?  Not clear.

If you read the previous threads you'd see that I tried contacting Control Products and they said that although it works with many/most VoIP methods, they don't provide support for it.  There are DIP switches, but none of them are in regards to dialing thresholds.


Thanks!

Terry


Make the changes from the OBiTALK portal page in expert mode.  Remove the check-marks from both of the two fields to edit the field, and then submit the change.  By default, the portal will overwrite the local configuration.  Don't try to edit it in both interfaces.

OBiTALK will initiate an automatic reboot of the device whenever a settings change necessitates a reboot to take effect.  Just wait a few minutes for it to happen.

TerryaG:
OK thanks for the clarification.

Also, it is showing a red exclamation in the HVICPowerThreshold and ChannelRxGain field when I change the latter, but haven't changed the former.  Normal?  Maybe one affects the other?

HVICPowerThreshold   !         help
DTMFPlaybackLevel            help
DTMFRxMode            help
CallerIDMethod            help
CallerIDTrigger            help
ChannelTxGain         *   help
ChannelRxGain   !

Thanks,

TG

Navigation

[0] Message Index

[*] Previous page