Ports over pap2 dail plan to Obi100

<< < (3/3)

RonR:
Ooops!  I forgot you're using an OBi100.

You should be able to use Trunk Group 1 instead.  Just like using the LINE Port, all the DigiMap rules will redirect to SP1 or SP2.


Physical Interfaces -> PHONE Port -> PrimaryLine : Trunk Group 1


Voice Services -> Gateways and Trunk Groups -> Trunk Group1 -> DigitMap:

(*<00:75>xx|<**2>*xxx|<**2>011xx.|<**2>**275*[x*][x*].|<411:**2**275*18004664411>|
<**2**275*>18(00|88|77|66|55)xxxxxxx|<**2**275*1>8(00|88|77|66|55)xxxxxxx|
<**1>1xxxxxxxxxx|<**11>[2-9]xxxxxxxxx|<**11614>xxxxxxx)

Dtan:
Ron,

Can a dial plan be created for this scenario.

When one of the service goes down other one will become the primary and all 7,10digits will route through it.

Is this possible. This may be a firmware development feature.

Thanks.

RonR:
Quote from: Dtan on July 15, 2011, 04:04:28 am

Can a dial plan be created for this scenario.

When one of the service goes down other one will become the primary and all 7,10digits will route through it.


A Trunk Group can specify multiple trunks, using the first one that is available, but it only has one DigitMap associated with it.  For example, if Trunk Group 1 were set to SP1,SP2, it would route calls matching its DigitMap to SP1 if available, otherwise SP2.

I don't think that's what you're looking for.

Navigation

[0] Message Index

[*] Previous page